[10-700-105] 2X1 Composite Video Switch 2 Input

Description

The 10-700-105 (2X1) is a composite video switch that is configurable to operate in several different modes of operation.

These modes include basic switch functions, matrix switch functions, and automatic switch functions.

Some modes can also provide a two output distribution function.

A USB port permits the user to change configuration parameters and store the changes into the internal Flash memory as the power up default settings.

The internal power supply is fully isolated to permit the user to control ground loops.

Single Unit Pricing $406.00

Features

GroupCustom
# Channels1
Inputs/Channel2
Outputs/Channel2
Input 1 Signal TypeComposite Video
Input 1 CouplingDC
Input Configuration 1Standard 75 Ohms
Input 1 ConnectorBNC
Output 1 Signal FormatComposite Video
Output 1 CouplingDC
Output 1 ConnectorsBNC
Power Connector4 pin 3.5mm TB
Input Voltage 112-24 VAC
Input Voltage 210-32 VDC
Height.6
Width4.4
Depth2.2
Weight Oz7
Low Operating Temp (C)-40
High Operating Temp (C)85
Control 1Contact Closure
Control 1 Connector3.5 mm 7 pin TB
Power BypassNO
MountingTwo 6-32 Insert

ASK A QUESTION OR REQUEST A QUOTE!


#


Power Supply

This unit has an isolated internal switcher power supply. The unit will operate correctly on 10-28 VAC or 10-32 VDC. The power input is protected so power can be applied in either polarity. The supply provides the internal electronics with power totally ground isolated form the power input. No opto electronics are used so the unit is not temperature limited by the isolated supply. The power connector is a four pin plug with jack screws so the power connection can support high vibration environments. In addition to the two pins used for power input, a third pin provides access to the internal electronics ground circuit. The fourth pin provides access to an internal chassis ground that connects to internal ESD protection devices.

Package

The package for this unit consists of a solid epoxy block. The internal electronics are assembled and tested before the encapsulation process. During the encapsulation the printed circuit board(s) are placed in a five sided box made of RTV mold parts. The cavity is filled with epoxy and the lid (top) of the mold is inserted. The curing process takes 24 hours. This type of package seals the electronics so water and contamination cannot affect the internal electronics. This type of package also provides superior resistance to shock and vibration compared to a metal or plastic box enclosure.